OPERATION
3
4
No.
44504MP
DC 19.2V
Cordless Impact Wrench
No.
44504MP
DC 19.2V
Cordless Impact Wrench
5.
Never
touch moving parts.
6. Be sure switch is
off position
before inserting battery.
7.
Always
wear eye protection.
8. If the cordless impact wrench overheat ( continuous use more than 15 min),
it will stop working before cold.
9. Do not touch the bit, drill, or the work-piece immediately after operation.
ASSEMBLING
○
Install The Battery.
○
Remove The Battery
.
Slide
Slide
CHARGING METHOD
1. Insert the plug of battery charger into the receptacle and pilot lamp will blink in red.
Rechargeable Battery
Battery Installation Hole
Pilot Lamp
THE INDICATORS OF THE CHARGER
Handle
Press
Release Button
2. Switch Direction & Off
CAUTION:
The push button can not be switched while the impact wrench is turning.
To switch the push button, stop the impact wrench, then set the push button.
NOTE:
A buzzing noise is produced when the motor is about to rotate;
this is only a noise, not a machine failure.
3. Hand Grip Usage
customer service e-mail: [email protected]
http://www.kingtony.eu
210x594 mm 8944504KTBE
1.Install The Socket
Pushbutton
Push(L)
Push(R)
CCW
CW
Off
(Middle)
REPLACING CARBON BRUSHES
Limit Mark
Brush Hold
Remove and check the carbon brushed regularly. Replace both carbon brushes when they
wear down to the limit mark.
●
RED
Fast Charging
Steady
Battery Full
●
GREEN
Flash
High Temperature Pause
Battery Low Volt
