9
1½” Male Adapter
(slip x MPT)
or
2” Female
Adapter
(slip x FPT)
Hard-Plumbed Installation
Do NOT install POOL
FROG off-line.
Following Primer directions, brush Primer on the inside of the
adapters and to ends of pipe. Repeat this process with PVC
cement following manufacturer’s directions on that product.
Measure the distance
between the outside
adapters and cut out a
section of pipe 3” less
than that dimension.
Allow a minimum
of 12” above and
on each side of
POOL FROG Cycler
to ensure room for
easy replacement of
POOL FROG Mineral
Reservoir and Pool
FROG Bac Pac.
Insert PVC pipe into adapters with
a twisting action. Hold in place 5 to
10 seconds to bond.
TOOLS NEEDED
Hacksaw
MATERIALS NEEDED
Tape
Measure
SECURE CYCLER
To prevent damage to heaters
or fi lters, see your dealer about
installing a
corrosion resistant
check valve
which will reduce the
back fl ow of chlorine gas when the
Cycler is turned off.
1.
2a.
2.
2b.
3.
Pipe Wrench
Bi-fl ow valve design allows
installation in either fl ow
direction.
Pipe Thread Tape
or Sealant, Primer and
PVC Cement
If using
male adapters
, apply
pipe thread tape or sealant to the
threaded end of each adapter.
Screw adapters into each end of POOL FROG Cycler following directions
for a male adapter or a female adapter. Hand tighten. Finish tightening
by turning 1 to 2 revolutions with a pipe wrench.
DO NOT OVER TIGHTEN.
4.
5.
The POOL FROG Cycler should always be installed
between the fi lter and pool (or between heater and pool if
applicable). Never install POOL FROG before the heater or
damage to the heater could occur.
Do NOT install in copper pipe if using
FROG Bac Pac as chemical corrosion
may lead to pipe failure.
Primer
For better stability,
POOL FROG Cycler
may be mounted on
a treated wood base
using
Phillips pan head
screws,
one in front
and two in back. If you
have questions about
stability, please contact
your dealer or King
Technology.
Primer
PVC
Cement
PVC
Cement
12"
12"
12"
If using
female adapters
, apply
pipe thread tape or sealant to the
threaded end of each feeder port.
OR
Install
