8
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread
Tape
or Sealant
Two Hose Adapters
1½” X 1½” X 1¼”
Two Sections of 1½”
or 1¼” Flex Hose
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eyeball fi ttings in the
return jets to a smaller or larger
size to adjust back pressure. For
best results use King Technology’s
pressure gauge, order part number
01-22-4000.
Apply pipe thread tape or sealant
to the threaded end of both hose
adapters.
1.
The POOL FROG Cycler should always be
installed between the fi lter and pool (or between
heater and pool if applicable).
Never install
POOL FROG before the heater or damage to
the heater could occur.
Base Flex-Hose Installation
Screw adapters into each end of POOL
FROG Cycler. Hand tighten. Finish
tightening by turning 1 to 2 revolutions
with a pipe wrench.
DO NOT OVER
TIGHTEN.
2.
Attach the fi lter section of fl ex hose to one
hose adapter and the return section of fl ex
hose to the other hose adapter with clamps
and tighten with screwdriver. Bi-fl ow valve
design allows water fl ow in either direction.
3.
To prevent damage to heaters
or fi lters, see your dealer about
installing a
corrosion resistant
check valve
which will reduce the
back fl ow of chlorine gas when the
Cycler is turned off.
4.
For better stability, POOL FROG Cycler may be
mounted on a treated wood base using
Phillips pan
head screws,
one in front and two in back. If you
have questions about stability, please contact your
dealer or King Technology.
5.
4/0//,
05-0
&),4%2
HOSE
CLAMP
HOSE
ADAPTER
HOSE
CLAMP
HOSE
ADAPTER
TO POOL
1 1/2" OR 1 1/4"
FLEX HOSE
1 1/2"
X
1 1/2"
X
1 1/4"
HOSE ADAPTER
HOSE
CLAMP
FILTER &
PUMP
CHECK
VALVE
