14
HOSE ADAPTER
TOOLS NEEDED
Screwdriver
Pipe Wrench
INCLUDED WITH FROG
Leap Infuzer
Pipe Thread Tape
or Sealant
One 6” X 1 1/2” TBE
PVC Nipple
MATERIALS NEEDED
One Hose Adapter
1 1/2” X 1 1/2” X 1
1/4”
One Section of
1 1/2” Flex Hose
(provided with filter)
One
Hose Clamp
RECOMMENDED
Corrosion Resistant
Check Valve
Above Ground, Filter Installation
Apply pipe thread tape or
sealant to each threaded end
of nipple.
Screw one end of nipple
into the filter return.
1.
2.
Tighten turning 1 to 2
revolutions with wrench.
DO NOT OVER TIGHTEN.
Screw either side of
FROG Leap Infuzer on
to open nipple end until
upright and secure.
Apply pipe thread tape or
sealant to threaded end
of hose adapter.
3.
4.
Screw adapter into the other
side of FROG Leap Infuzer.
Hand tighten. Finish tightening
by turning 1 to 2 revolutions
with wrench.
DO NOT OVER TIGHTEN
.
5.
6.
Attach return section of hose
to the adapter with clamp.
Tighten clamp with screwdriver.
7.
If using a FROG Leap Torpedo
Pac, installing a corrosion
resistant check valve is
recommended.
