King Long XMQ6900 Series, Руководство по эксплуатации

Страница: 73 / 173

Vehicle Starting and Driving
4-3
3 Fuel pre-filter with water separator (drain accumulated water)
Draining accumulated water
On a daily basis, check the lower cup of the water separator. If there is water in the cup, unscrew the
draining plug one or two turns, to drain the accumulated water.
After draining the water, tighten the draining plug correctly.
When the accumulation of impurities in the lower cup is noticed, take the vehicle to a workshop to carry
out its cleaning.
Changing the fuel pre-filtering element
The fuel filtering element should be changed periodically,
at the intervals recommended in the maintenance manual.
If however, the filtering element is easily saturated
needing substitution at very short intervals, this is an
indication of the accumulation of impurities in the
interior of the fuel tank, and the cleaning of the latter
should be carried out.
In order to change the fuel filter element, take the
vehicle to a Dealer or a King-Long Workshop.
Fuel system discharge
Activate the manual pump until feeling resistance on
pumping.
Start up the engine without accelerating. If the engine
does not start running in 20 seconds, interrupt the startup
and wait at least one minute before trying again.
If the engine insists on not working, repeat the discharge
operation.
Leave the engine running for about a minute to
completely eliminate the air from the system by way of
the auto-discharge system.
In order to reduce environment pollution problems, do
not drain the residues accumulated in the water separator
directly into Nature (rivers, lakes or soil). The drained
residues should be collected in appropriate containers
and taken to receiving centers to have proper final
destination (see local legislation).
Model for Euro III IV
Manual pump
Release valve