King Kooker C90NG, Инструкция по сборке и эксплуатации, Страница: 13 / 24

13
9. When the quick disconnect socket and the gas hose are connected, a valve in the quick
disconnect socket will open automatically and permit gas flow (the gas supply shut-off valve must be
turned to an ON position to allow gas flow.) When the gas hose is disconnected, the valve in the quick
disconnect socket will instantly and positively shut off the flow of gas. The gas must be turned OFF
at the natural gas supply by closing the gas supply shutoff valve and removing the gas hose from the
quick disconnect socket when the appliance is not in use.To remove the hose, pull back the sleeve
on the quick disconnect socket and pull out the hose. The quick disconnect socket should be left at-
tached to the gas source (house piping.) When the gas hose is removed from the quick disconnect
socket, re-insert protective plugs into the socket and gas hose.
10. Disconnect your appliance from the gas supply when the gas supply is being tested at high
pressures. This appliance (including hose and the appliance valve) must be disconnected from the
gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2
psig (3.5 kPa).
11. Use of a hose in excess of 12 feet (3.66 m) or a hose with a kink may result in a restriction of the
flow of gas to the cooker and poor performace of the cooker. Always use the hose assembly supplied
with the appliance. Before each use of the appliance check the hose for evidence of kinks, abrasion, wear,
cuts or leaks. If there is any damage to the hose, the hose assembly must be replaced prior to using the
appliance. Contact Metal Fusion, Inc. at (800) 783-3885 for information regarding a replacement hose
assembly. Only the hose assembly specified by Metal Fusion, Inc. should be used with the appliance.
8. Remove the protective plugs from the quick disconnect socket and unattached end (male) of the gas
hose. Pull back the sleeve on the quick disconnect socket and insert the unattached end (male) of the
gas hose into the socket. See Figure 3 below. Release the sleeve and continue pushing the hose into
the socket until the sleeve snaps into the locked position. Figure 4 below shows a properly connected
gas hose and quick disconnect socket.
FIGURE 3
FIGURE 4
QUICK DISCONNECT
SOCKET APPLIANCE
HOSE
MALE
END
GAS SUPPLY
PIPING
SHUT-OFF
VALVE
(OFF)
SLEEVE (PULL BACK)
SHUT-OFF
VALVE
(OFF)
GAS SUPPLY
PIPING
QUICK DISCONNECT
SOCKET
APPLIANCE
HOSE
* Model May Vary From Picture
* Model May Vary From Picture