ASSEMBLY
This mobile base is universal and is designed to fit a wide range of table
saws. All table saws with extension table and supporting legs may differ
in overall dimensions (table width/table height), therefore some small
modifications may be required in order to support the table saw and the
support legs adequately. Also, it is important to use this mobile base on
a level surface.
1. Assemble the 2 front support brackets (A & B) Fig.1 together to the de-
sired width using 4 carriage bolts (C) and flange head hex. nuts (D).
Note: Install the carriage bolts (C) on the inside of the mobile base and
the flange head hex. nuts (D) on the outside.
2. Assemble the wheel brackets (E) Fig.1 to the front support brackets (A
& B) using 4 flange head hex. bolts to secure each wheel bracket.
3. Assemble the 2 rear support brackets (A & B) Fig.2 together to the
identical width set in step 1, secure the brackets together using 4 car-
riage bolts (C) and flange head hex. nuts (D).
Note: Install the carriage bolts (C) on the inside of the mobile base and
the flange head hex. nuts (D) on the outside.
4. Slide two brace bars (E) Fig. 2 into the rear support bracket assembly,
then side the other ends into the front support bracket assembly. Keep
in mind your desired width and adjust accordingly. Secure the brace
bars to the front and rear support bracket assemblies using 8 hex. bolts
(F).
5. Assemble the fixed wheels (A) Fig.3 to the rear support bracket as-
sembly using a large hex. bolt (B) and washer (C) on each side.
6. Assemble the front swivel casters (A) Fig.4 to the wheel brackets (B)
using a large washer (C) and hex. nut (D).
WARNING! Once table saw is installed on the mobile base, it is very im-
portant to lock the swivel casters (A) Fig.4 by lowering both locking levers,
this will prevent all movement of the mobile base during operation.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
