ASSEMBLY
ASSEMBLING SOLID EXTENSION TABLES
2 Solid extension tables are supplied and can be assembled to the front and
back of your planer table. To install either extension table (A) Fig.5, hold the
extension table against the front of the table and using 3 hex. bolts (B) Fig.5,
fix the extension table to the table. Do not completely tighten the hex. bolts.
To adjust the extension table parallel with the table surface, place a straight
edge on the top of the table and extension table (Fig.5B). Adjust the
extension table angle by tightening or loosening the 3 set screws (C) Fig.5
until the table extension and the main table are perfectly parallel. Tighten all
hex. bolts and recheck the alignment and adjust if necessary.
Repeat the above steps for the rear extension table.
ASSEMBLING TABLE HEIGHT ADJUSTMENT HANDWHEEL
1) Place bushing (A) Fig.6 on the handwheel shaft.
2) Insert retaining key into the handwheel shaft keyway.
3) Thread the handle (B) into the handwheel (C).
4) Place the handwheel onto the shaft and secure it into place with a
washer (D) and hex. nut (E).
5” DUST COLLECTOR HOOD
This standard accessory dust collector hood (A) Fig.7 is assembled to the
rear of the planer using 5 hex. bolts and washers (B). Connecting a dust
collector to your planer IS HIGHLY RECOMMENDED because it provides an
efficient means of maintaining a clean and safe work area.
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 5B
