belt replacement continued...
5) Remove the two cap screws (A) Fig.19 located in the top of the right cover (C)
using a 5 mm hex. key.
6) Remove the centre panel (B) Fig.19 and the right cover (C).
7) Remove the flat head allen screw (B) Fig.8 with the supplied 4 mm hex. key, then
pull and slide the cover (C) downwards to remove it.
8) Once the cover has been removed, loosen the lock hex. nut (A) Fig.20, once
loose loosen and remove the depth stop knob (B).
9) Remove the plastic side housing (C) Fig.20.
10) Pull on the belt (A) Fig.21 while turning the motor pulley counterclockwise until
the belt comes off the cutterhead pulley (B).
11) Remove the belt from around the upper motor pulley.
12) Install the new belt on the upper motor pulley first.
13) Slide the belt onto the edge of the cutterhead pulley (B).
WARNING!
TO REDUCE RISK OF INJURY KEEP FINGERS ON TOP OF THE
THE BELT.
14) Turn the upper motor pulley until the belt seats properly on both pulleys.
15) Reinstall all parts removed in steps 3 to 9 in the reverse order.
MAINTENANCE
FIGURE 19
FIGURE 20
FIGURE 21
