ASSEMBLY
ASSEMBLING MOTOR, MOTOR PLATE AND GUARD BRACKET
Make sure the motor is DISCONNECTED from the power source and
assembled as follows:
1. Assemble the 2-1/2” carriage bolt (A) and washer (C) to the pulley guard
bracket using nut (B) as shown in Fig.10.
2. Put the motor up-side down on the floor or bench and place the guard
bracket (A) and mounting plate (B) on the motor as shown in Fig.11.
3. Assemble motor plate and guard bracket to the motor frame using the four
hex bolts, eight flat washers, eight shakeproof lockwashers and four nuts
in the same order as shown in Fig.12. The guard bracket should be
positioned where it will not vibrate against the motor housing or rub
against the V-belt or pulley.
4. Fig.12 illustrates the proper relationship of the motor mounting hardware.
IMPORTANT: The proper grounding of the motor, to prevent shock hazard,
depends on the use of the shakeproof lockwashers in the manner shown in
Fig.12.
ASSEMBLING MOTOR BRACKET
1. Assemble motor bracket (A) and assemble rod (C) to the bracket as shown
in Fig.13. Make sure the screw that holds the rod (C) in place is tightened
into the V-groove on the rod.
2. Assemble the motor assembly onto the two posts (A) and secure with set
screws (B) as shown in Fig.14.
NOTE: Make sure the two posts are well into the motor bracket and are
evenly spaced.
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13
FIGURE 14
