ADJUSTING BELT TENSION
The jointer comes with two V-belts installed and properly tensioned to the
cutterhead and motor pulley. If it becomes necessary to adjust belt tension,
proceed as follows:
1. DISCONNECT THE MACHINE FROM THE POWER SOURCE.
2. Loosen knob (A) Fig.16 and pull the handle latch (B) upwards and open rear
hinged door (C).
3. To adjust belt tension, turn nuts (A) and (B) Fig. 17 to move motor plate (C) up
or down until there is approximately 1/2” deflection in the center span of the
V-belts (D) using light finger pressure.
ADJUSTING SPRING TENSION OF CUTTERHEAD GUARD
The cutterhead guard (A) Fig. 18, completely covers the cutterhead. During
operation the material being jointed or planed pushes the guard out of the way
and at the completion of the cut, the guard springs back over the cutterhead
providing full coverage. If it ever becomes necessary to adjust the spring tension
of the cutterhead guard, loosen two set screws (B) and turn screw (C) clockwise
to increase or counterclockwise to decrease the spring tension. Then retighten
the two set screws (B).
Warning! Before operating jointer, check guard to make sure it functions properly
and quickly returns to the closed position.
ADJUSTMENTS
FIGURE 16
FIGURE 17
FIGURE 18
