King-Dome 9630, Руководство по устранению неисправностей

Страница: 12 / 32

1. Turn TV and satellite receiver on.
2. Go to the signal meter screen on TV.
Choose transponder number: Dish Network #11
DIRECTV #19
3. Enter local ZIP code on signal meter screen to determine satellite
elevation. If you do not know your local zip code, determine your
elevation from the elevation maps in the Reference Section.
4. Press and hold UP/ON arrow on King-Dome Controller for
3 FULL SECONDS to turn King-Dome on.
5. Press UP or DOWN arrow on King-Dome Controller to match
elevation on Controller to elevation on TV signal meter screen or
elevation from the elevation maps in Reference Section.
6. Press and hold RIGHT arrow until Controller begins RAPIDLY
flashing its clock position (7-10 seconds).
Remember, you must watch for signal strength on TV!
Dish will automatically perform a 360 degree scan for satellite.
When signal strength appears on TV, momentarily press
ANY BUTTON to stop the dish from rotating.
7. Press the UP, DOWN, LEFT or RIGHT arrows to fine tune signal
strength to the highest possible number on TV signal meter screen.
Enjoy your programming!
IMPORTANT! In Step 6, as soon as you begin holding the right arrow, you
must continuously monitor the TV signal meter screen until
signal appears on TV.
Note: The Controller will flash a series of codes and then display its elevation. Wait for the
Controller to steadily display the elevation before continuing (about 10 seconds).
Page 10
BASIC OPERATION
Serial Number 170000 and higher
SECTION 4
SERIAL # 170000 AND HIGHER