King Canada KCG-2000i Скачать руководство пользователя страница 9

WATTAGE CALCULATIONS

WATTAGE CALCULATIONS

IMPORTANT! Never exceed the rated capacity of your generator.
Serious damage to the generator or appliance could result from an
overload.

1) “Starting” and “Running” wattage requirements should always be

calculated when matching a generators wattage capacity to the
appliance or tool.

2) There are two types of electrical appliances that can be powered by

your generator;

a) Items such as radios, light bulbs, televison sets, and microwaves

have a “resistive load”. Starting wattage and running wattage are
the same.

b) Items such as refrigerators, air compressors, washer, dryer and

hand tools that use an electrical motor have an “inductive load”.

Inductive load appliances and tools require approx. 2 to 3
times the listed wattage for “starting” the equipment.

This

initial load only lasts for a few seconds on start-up but is important
when figuring your total wattage to be used.

Always start your largest electric motor first, and then plug in other
items, one at a time.

Wattage Requirement Chart below

- This is only a guideline, each

appliance or electrical device needs to be checked for its specific
operating load.

DETERMINING WATTAGE REQUIREMENTS

Note: Volts X Amps = Watts
Example: 120V X 16.7 Amps = 2000 Watts

Before operating this generator, list all of the appliances and/or tools
that are going to operate at the same time. (Then determine the
starting wattage requirements and the running wattage requirements
by following the example below;

1) Add the total amount of the running wattage of all appliances and/or
tools that will be operated at the same time.
Example 1A:
Lights = 100 Watts (Running)
Television = 135 Watts (Running)

TOTAL = 235 Watts (Running)

2) Next add the total amount of the starting wattage of any appliances
and/or tools that will start and stop during operation.
Example 1B: 
Small refrigerator 500 Watts (Running) 2000 Watts (Starting)

TOTAL = 500 Watts (Running) 2000 Watts (Starting)

3) The running wattage of examples 1A & 1B totals 735 watts. The
starting wattage of the small refrigerator is 2000 watts which is 1265
watts more than the running watts. Take this difference of 1265
starting watts from the refrigerator and add to the total running watts of
735. Therefore:

1265 Starting Watts + 735 Running Watts = 2000 Total Watts
The generator required to operate the items in example 1A & 1B
must have a minimum capacity of at least 2000 starting watts.

Содержание KCG-2000i












Отзывы: