FOLDING/UNFOLDING STAND
Warning:
Disconnect GFCI plug from power source before attempting to fold and
move the Tile Saw.
1) Before folding the stand, the water tray must be emptied of all water, the 3
extension trays need to be removed and placed inside the water tray, and the
sliding table needed to be locked to prevent it from sliding.
2) To close or “fold” the folding stand, step on the foot release lever (A) Fig.26, and
raise the two handles (B). Raise the two handles until the foot release lever (A)
clicks and locks. Fig.26 shows the stand in the folded position, the Tile Saw can
now be tilted and rolled around.
3) To open or “unfold” the folding stand, step on the foot release lever (A) Fig.26, and
lower the two handles (B) to raise the entire Tile Saw in the upright open position.
Lower the two handles until the foot release lever (A) clicks and locks. The Tile
saw can now be used in its new location.
MAINTENANCE
WARNING: DO NOT SERVICE, CLEAN, OR MAINTAIN THE SAW WITHOUT
FIRST TURNING OFF THE MOTOR AND UNPLUGGING THE SAW FROM ITS
POWER SOURCE. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY TO
THE OPERATOR.
For the longest life and best performance, clean the Tile Saw after every use. Wipe
off all exterior surfaces and keep the sliding table clean and free of tile chips and
debris. Wipe off both the guide bars and the rollers of the sliding table. Always check
the blade for cracks or signs of fatigue.
Lubrication
All of the bearings in this Tile Saw are lubricated with a suffi cient amount of high
grade lubricant for the life of the unit under normal operating conditions. After
extended use, clean the rails so the sliding table will slide smoothly.
Cleaning
• Unplug the Tile Saw and water pump.
• Empty the dirty water from the water tray.
• Rinse off the sliding table.
• Unlock table stop, remove table from rails, rinse the rails and water tray frame. It is
important to clean the rails often.
Cleaning the water pump
• Unplug water pump before handing or cleaning.
• Using a small brush and/or water, clean any debris or trash that is trapped on the side of the water pump.
CAUTION:
To maintain effi ciency and to extend the life of the water pump, check intake screen before use to make sure it is clean.
Carbon brush replacement
This Tile Saw has externally accessible carbon brush assemblies that should be periodically checked for wear. Proceed as follows when
replacement is required:
• Unplug the Tile Saw.
• Remove carbon brush cap (A) Fig.27 with a flat head screwdriver (not included). The carbon brush assembly (B) is spring loaded and will pop
out when you remove brush cap (A). Remove carbon brush assembly (B).
• Check for wear. Replace both carbon brushes when either has less than 1/4” in length of carbon remaining. DO NOT replace one side without
replacing the other side.
• Reassemble using new carbon brush assemblies (not included). Reinstall brush caps (A). Tighten brush caps securely. Do not overtighten.
FIGURE 27
FIGURE 26
OPERATION & MAINTENANCE
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.
