ASSEMBLY
SETTING UP THE TRIPOD
1. Loosen the tripod locking knob (A) Fig.4.
2. Push down the leg connector (B) until the legs (C)
are fully extended, then firmly tighten the locking
knob (A).
3. Adjust the height of the tripod by loosening the
twist collars (D) and raising the center poles (E) of
the tripod. Firmly tighten the twist collars when the
tripod reaches the desired height.
NOTE: The maximum height of this tripod is 51".
ATTACHING CARRYING HANDLE TO BASE
1. Place the carrying handle (F) Fig.4 vertically on
the base (G).
2. Use two bolts (H), flat washers and spring
washers to secure the carrying handle on the base
as shown in Fig.4.
ATTACHING WORK LIGHTS TO BASE
1. Place the base (G) Fig.4 on a flat surface.
2. Use the lock knobs (I), flat washers and spring
washers to secure both work lights (J) on the sides
of the base as shown in Fig.4.
3. Use a long knob (A) Fig.5 to attach the power
cable connector (B) to the carrying handle (C) as
shown in Fig.5.
ATTACHING THE WORK LIGHT ASSEMBLY TO
THE TRIPOD
1. Place the work light assembly on the top of the
tripod. The bottom of the base cross bar (A) Fig.6
needs to be sitting in the bracket (B).
2. Place two buckles (C) as shown in
Fig.6, lift the quick release latch (D) over
both buckles (C) and lower the lever (E)
to fasten them.
3. Remove the work light assembly from
the bracket in the opposite way.
ASSEMBLY
FIGURE 4
FIGURE 5
FIGURE 6
