6” JOINTER ASSEMBLY
ASSEMBLING JOINTER TO STAND
1. WARNING: JOINTER WEIGHT IS APPROXIMATELY 175 LBS.
CARE MUST BE TAKEN WHEN LIFTING JOINTER ONTO
STAND. A MINIMUM OF TWO PEOPLE WILL BE REQUIRED TO
LIFT THE MACHINE.
2. The infeed end of the jointer is fastened to the two holes (A) Fig. 5, and
the outfeed end of the jointer is fastened to hole (B) on the top end
braces.
NOTE:
Dust chute (C) is on outfeed end of jointer. Line up the
three threaded holes on the bottom of the jointer with the three holes
(A) and (B) in the stand end braces.
3. Using the supplied wrench, fasten the jointer to the top of stand using
the three lock washers and special studs. Two of the special studs are
shown at (D) Fig. 6, for the infeed end of the machine, and one special
stud is shown at (D) Fig. 7, for the outfeed end of the machine.
4. Once the jointer is completely secured to stand, push downward on
the top of jointer until the stand adjusts to the floor surface. Then,
using the supplied wrench, tighten all stand hardware.
ASSEMBLING DUST CHUTE COVER
1. Assemble dust chute cover (A) Fig. 10, to dust chute (B) using two
wing screws (C). IMPORTANT: Top of dust chute cover (A) must be
inside top end brace (D) of stand and should completely cover the top
of the dust chute.
WARNING:
During operation, the dust chute cover
(A) must always be assembled as shown and should only be removed
for cleaning.
ASSEMBLING DUST COLLECTOR ADAPTER
If the machine is to be connected to a dust collection system, a dust
collector adapter with a 4˝ O.D. opening is supplied with the jointer. To
assemble the adapter:
1. Remove two wing screws (C) Fig. 10, from dust chute cover (A).
2. Assemble adapter (E) Fig. 11, over dust chute (A). Align two holes in
dust chute (A) with holes in adapter (E) and fasten with two wing
screws (C) which were removed in
STEP 1.
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 10
FIGURE 11
