GETTING TO KNOW YOUR VACUUM,
ELECTRICAL INFO & SPECIFICATIONS
SPECIFICATIONS
Model
..........................................................................8531LP-B
Voltage
................................................................................110V
Horsepower
............................................................5 HP (peak)
Amperage
............................................................................10A
Phase
........................................................................................1
Hertz
..................................................................................60Hz
Tank size
................................................8 Gallon (US)/30 liters
Air flow
........................................................................127 CFM
Vacuum pressure (inches of water)
................................58.4”
POWER SUPPLY- WARNING:
YOUR VACUUM MUST BE
CONNECTED TO A 110V, MINIMUM 15-AMP. BRANCH CIRCUIT.
FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY
FROM SHOCK OR FIRE.
WARNING
: The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations
that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.
DOUBLE INSULATION
Double insulated tools are equipped with a polarized two-prong plug
(one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician to install a
polarized outlet. Do not alter or change the plug in any way. Double
insulation eliminates the need for three wire grounded power supply
and grounded power cords. See Fig.1.
EXTENSION CORDS
Improper use of extension cords may cause inefficient operation of your
tool which can result in overheating. Be sure your extension cord is
rated to allow sufficient current flow to the motor. If you are using the
tool outdoors, use an extension cord rated for outdoor use (signified by
“WA” on the jacket). The extension cord must have a minimum wire size
depending on the amperage of the tool and the length of the extension
cord. This size is determined by its AWG (American Wire Gauge)
rating. The smaller the gauge, the greater the cable’s capacity. The
amount of cords used does not matter: Total length determines the
minimum AWG rating. Every cord must meet the AWG rating. Use the
chart Fig.2 to determine what AWG rating is required for your situation.
Cord length is rated in feet.
FIGURE 1
LENGTH OF
CONDUCTOR
0-25 FEET
26-50 FEET
51-100 FEET
WIRE SIZES REQUIRED
(AMERICAN WIRE GAUGE)
110V LINES
NO.14
NO.14
NO.12
FIGURE 2
110V POLARIZED PLUG & OUTLET
POLARIZED PLUG
POLARIZED
OUTLET
1) 1-1/4” x 6ft. twist lock hose
2) 2-1/2” blower extension
3) 2-1/2” blower nozzle
4) Top carry handle/detachable blower
5) 2pc extension wands
6) 2-1/2” cone nozzle
7) Latch (1 of 2)
8) Twist lock inlet
9) 1-1/4” crevice tool
10) Tank drain cap
11) 1-1/4” x 10” floor sweep
12) 2-1/2” blower adaptor fitting
13) Re-usable filter
14) Foam filter
15) Blower release button
16) On/Off switch
17) 2-1/2” blower outlet
ELECTRICAL INFO &
SPECIFICATIONS
GETTING TO KNOW YOUR VACUUM
