ASSEMBLY
BLOWER MODE
Align the grooves on the blower tube (A) Fig.4 with the grooves on the blower
outlet (B). Push the blower tube onto the blower outlet until it clicks into
position.
Warning!
The blower inlet and outlet both have a built-in limit switch which
prevents the blower from starting if the blower tube (A) and the blower inlet
safety guard (C) are not installed or not installed properly. Make sure the
blower tube and blower inlet safety guard are installed before attempting to use
the blower.
To install the blower inlet safety guard (A) Fig.5 to the blower inlet, position the
blower inlet safety guard over the blower inlet, rotate the safety guard
approximately 90 degrees. Make sure the safety guard has engaged the
blower inlet grooves, at this point you must not be able to lift the safety guard
upwards. Make sure the limit switch actuator (B) engages the inner limit switch,
then lock the blower inlet safety guard using the locking clip (C). The blower is
now ready to use, make sure you have read and understood the safety and
operation instructions before using.
It is recommended to install the adjustable shoulder strap (D) Fig.4 to the
blower handle (E).
VACUUM/MULCHER MODE
Warning!
The vacuum/mulcher inlet and outlet both have a built-in limit switch
which prevents the vacuum/mulcher from starting if the main collection tube
(A) Fig.6 and the collection bag attachment (C) are not installed or not installed
properly. Make sure the vacuum/mulcher main collection tube and the
collection bag attachment are installed before attempting to use the
vacuum/mulcher.
In vacuum/mulcher mode, the main collection tube (A) Fig.6, lower section
collection tube (B) and the collection bag attachment (C) with collection bag
must be installed. First, remove the blower inlet safety guard (A) Fig.5 (if
installed). Then install the main collection tube (A) to the vacuum/mulcher inlet,
position the main collection tube over the vacuum/mulcher inlet, rotate the
collection tube approximately 90 degrees. Make sure the collection tube has
engaged the vacuum/mulcher inlet grooves, at this point you must not be able
to lift the collection tube upwards. Make sure the limit switch actuator engages
the inner limit switch, then lock the collection tube using the locking clip (refer
to “B” & “C” Fig.5).
Install the lower section collection tube (B) Fig.6 to the main collection tube (A).
Align the grooves on both collection tubes and push them together until they
click into position.
Then install the collection bag and attachment (C) Fig.6 to the vacuum/mulcher
outlet (D). Align the grooves on the collection bag attachment with the grooves
on the vacuum/mulcher outlet. Push the collection bag attachment onto the
vacuum/mulcher outlet until it clicks into position. Attach the collection bag
buckle to the clip on the lower section collection tube. The vacuum/mulcher is
now ready to use, make sure you have read and understood the safety and operation instructions before using.
It is recommended to install the adjustable shoulder strap (D) Fig.4 to the vacuum/mulcher handle (E).
FIGURE 4
FIGURE 5
FIGURE 6