ADJUSTMENTS & OPERATION
Circular Cutting
Circular cutting may be accomplished if you
assemble the straight guide and guide plate as
shown in Fig 10. (Min. 2-3/4” to 4-3/4”, Max.
4-3/4” to 8-11/16”). Minimum radius is 2-3/4” and
maximum radius is 8-11/16”.
Note
: Circles
between 6-3/4” and 7-5/16” in radius can’t be cut
using this guide.
Align the centre hole in the straight guide with the
centre of the circle to be cut. Drive a nail less
than 1/4” in diameter into the centre of the hole to
secure the straight guide. Pivot the tool around
the nail in a clockwise direction.
Trimmer Roller Guide
Trimming curved cuts can be done easily with the
trimmer roller guide (A) Fig.11. The roller guide
(B) rides the curve and assures a fine cut.
Loosen the fixed base lock knob (C) Fig.11. Slide
the trimmer roller guide (A) under the lock knob
and tighten to secure in place.
Loosen the fixed base lock knob (C) and adjust
the distance between the bit and the trimmer
roller guide by turning the adjust knob (D), 3/64”
(1mm) per turn. At the desired distance, tighten
the lock knob to secure the trimmer roller guide
in place. When cutting, move the tool with the
guide roller riding the side of the workpiece.
Installing Plunge Base/Using as a Plunge
Router
To use this tool as a plunge router, first the fixed
base must be removed from the tool, then install
tool into plunge base.
Undo plunge base clamp (A) Fig.12 and slide tool all the way down into the plunge base
(B), secure tool in plunge base using the clamp (A).
Figure 10
Figure 11
Figure 12
