ADJUSTMENTS, OPERATION
& MAINTENANCE
Installing/Using Straight Guide on Plunge
Base continued...
Loosen the plunge base lock knob (A) Fig.14
found on the guide holder (B). Slide the straight
guide under the lock knob and tighten to secure
in place. Loosen the wing nut on the straight
guide and adjust the distance between the bit
and the straight guide.
You can also extend the guide holder (B) by
loosening the two lock knobs (C), pulling out the
guide holder and retightening the two lock knobs.
Once set to the desired distance, tighten the
wing nut securely. There are two holes in the straight guide which allow the carriage bolt,
washer and wing nut to be installed further away.
When cutting, move the tool with the straight guide flush with the side of the workpiece.
MAINTENANCE
IMPORTANT
: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustments should be performed by an authorized service center or other qualified
service technician, always using identical replacement parts.
1. Air vents of the tool should be cleaned regularly to avoid overheating of the motor which
is caused by the blocking of the air vents.
2. DON’T clean this tool with water, as no liquid is allowed in the tool body. Clean the tool
with a dry clean cloth only. Compressed air at low pressure is also suitable.
3. DON’T allow petroleum based products to come into contact with the plastic parts of the
tool, as they contain chemicals that can damage or destroy the plastic parts.
CARBON BRUSHES
Remove and check the carbon brushes regularly (normally after 50 hours of use). The
carbon brushes will need to be replaced once the carbon brushes wear down to the limit
mark. Both carbon brushes should be replaced at the same time.
Using a flat head screwdriver, remove the carbon brush caps (A) Fig.15. Remove the
carbon brush (B) and inspect it. Repeat this step
for the second carbon brush on the opposite
side.
If they have worn down, you will need to replace
them with a set of identical replacement carbon
brushes (included). Install new carbon brushes
and reinstall the carbon brush caps.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada
web site for the most updated parts diagram and
parts list.
Figure 14
Figure 15
