GETTING TO KNOW YOUR TOOL
1. Front grip
2. Variable speed dial
3. Trigger lock-on button
4. Dust bag
5. 3” x 21” Sanding belt (100 grit)
6. Sanding belt tracking knob
7. Drive belt cover
8. Rear handle grip
9. Power cord (polarized, 120V, 60Hz)
10. On/Off trigger
11. Sanding belt tension lever
ADJUSTMENTS & OPERATION
TURNING YOUR BELT SANDER ON/OFF
Warning
! Always hold the belt sander firmly
with both hands while sanding.
To start the belt sander, press the On/Off
trigger (A) Fig.1. To stop the belt sander,
release the On/Off trigger. For continuous
operation, press and hold the On/Off trigger
(A) and then press the lock-on button (B), you
can now release the On/Off trigger and the
belt sander will continue to operate without
holding the trigger. To stop the belt sander,
press then release the On/Off trigger.
ADJUSTING VARIABLE SPEED
To change the sanding belt speed, turn the
variable speed dial (C) Fig.1. The higher the
setting, the faster the sanding belt will turn.
CHANGING THE SANDING BELT
To change the sanding belt, pull tension lever
(A) Fig.2 as shown to release the belt tension.
Pull the sanding belt off the two rollers (B).
Before placing the new sanding belt, make
sure the arrow on the inside of the sanding
belt corresponds to the direction of the arrow
on the sander (C). Also make sure the rear
roller is free of all debris before installing belt.
Place the new sanding belt in place around
the two rollers, the belt should be centered
between the front and the rear rollers. Push
the tension lever (A) towards the rear to
tension the sanding belt.
ADJUSTING SANDING BELT TRACKING
To adjust the sanding belt tracking, turn the
sander upside down. Hold the sander firmly
with one hand, start the motor and release the
On/Off trigger immediately after observing the
belt tracking. If the sanding belt runs outward,
turn the tracking knob (A) Fig.3 clockwise and
counterclockwise if the sanding belt runs
inward. Make this adjustment until the outer
edge of the belt is even with the outer edge of
both rollers (B).
Figure 1
Figure 2
Figure 3
