GETTING TO KNOW YOUR TOOL
1. Carrying case
2. Oscillating multi-tool
3. On/Off switch
4. Variable speed selector dial
5. Oscillating spindle & mounting hardware
6. Sanding back-up pad with hook & loop backing
7. 15 pcs. Sanding paper (60, 80 & 120 grit) with hook & loop backing
8. HSS segment saw blade
9. 52mm rigid offset scraper blade
10. 35mm Tru-cut narrow offset saw blade
11. Set of replacement carbon brushes
12. Mounting hardware hex. key (6 mm)
SPECIFICATIONS
Model......................................................................................................................8348VS
Amperage ....................................................................................................................1.8A
Voltage........................................................................................................................120V
Cycle/Phase ................................................................................................60Hz, 1 phase
Oscillations per minute ..............................................................................15,000 - 21,000
Insulation class ........................................................................................................Double
ASSEMBLY
INSTALLING ACCESSORIES TO MULTI-TOOL
WARNING:
Do not plug in power cord until the accessory is installed securely to the tool.
This kit comes with 4 different accessory attachments, a HSS Segment Saw Blade (A)
Fig.1, 52mm Rigid Offset Scraper Blade (B), Sanding Pad (C) with hook & loop backing
(and 15 sanding papers, 5 x 60, 80 and 120 grit) and a Standard 35mm Narrow Tru-cut
Offset Saw Blade (D). One accessory at a time can be installed to the multi-tool. To secure
the accessory to the multi-tool, use the special washer and cap screw (E) and the 6mm
hex. key (F).
Installing HSS Segment Saw Blade, 52mm Rigid Offset Scraper Blade and 35mm
Narrow Tru-cut Offset Saw Blade
The installation procedure for these 3 accessories is identical. Position the accessory as
shown in Fig.1 and place it over the shaft flange (G). Position the washer (serated side)
over the accessory and screw cap screw using hex. key supplied. Make sure the
accessory is properly seated before tightening cap screw.
WARNING
: Do not tighten the cap screw (E) unless the accessory is properly seated on
the shaft flange, if you secure the accessory to the shaft without the accessory properly
seated, the accessory may suddenly move during an operation, resulting in possible injury.
Installing Sanding Pad with hook & loop backing (15 sanding papers, 5 x 60, 80 and 120 grit)
The installation procedure for this accessory requires an additional step. Position the
Sanding Pad (C) as shown in Fig.1 and place it over the shaft flange (G). The supplied
washer can not be used when installing Sanding Pad. Screw cap screw using hex. key
supplied. Make sure the accessory is properly seated before tightening cap screw. Then
align and press the sanding paper onto the Sanding Pad, turn tool over and press it against
a flat surface.
WARNING
: Do not tighten the cap screw (E) unless the accessory is properly seated on
the shaft flange.
Figure 1
