Item No. KF10B 0112
KF10B Installation
1.
Before installing the faucet, open the hot and cold
water supply lines for several seconds to flush out
any scale, solder, or other impurities that would
otherwise damage the faucet. Then close the
water supply stops.
2.
Stainless steel braided supply hose (items 26 and
27) has been supplied with the faucet. Install the
supply hose to the faucet taking care to match the
hose and faucet colour code (red indicates hot
water supply and blue indicates cold water
supply). Tighten the hose until the o-ring seats.
3.
Ensure that rubber gasket (item 15x1) is mounted
to the base of faucet, with flat surface of gasket
facing up and the contoured surface of the gasket
facing down to seal to countertop, or sink.
4.
Insert the faucet body through the faucet hole.
5.
Position faucet with desired orientation of handle
(item 19x1). Faucet may mounted with handle on
center, or handle on left hand side, or handle on
right hand side.
6.
Tighten the faucet to the countertop or sink with
plastic mounting bracket (item 22x1) and black
rubber gasket (item 21x1) and stainless washer
(item 23x1) all clamped in place with stainless hex
nut (item 24x2).
Assembly of components as follows:
Faucet above counter
Countertop
1st plastic mounting bracket (item 22)
2nd black rubber gasket (item 21)
3rd stainless washer (item 23)
4th stainless hex nut (item 24)
7.
Tighten stainless hex nut (item 24) with tool to
snug faucet in correct position. Lock hex nut by
tightening machine screws (item 25x2).
8.
Assemble spray head (item 1x1) and rubber
gasket (item 2x1) to flexible spray hose connector
(item 3x1).
9.
Connect stainless braided supply hose (items 26
and 27) to their respective supply lines.
10.
Ensure that faucet lever is in the off position and
then turn water supply back on and check for
water tight seal. Retighten where necessary, but
do not overtighten.
4
5
6
7
1
2
3
8
9
10
11
12
13
14
15
16
17 18
19
20
21
22
23
24
20
25
26
27
01 Spray Head
02 Rubber Washer
03 Flexible Hose Connector
04 Flexible Hose
05 Rubber Washer
06 Flexible Hose Nut
07 O Ring
08 Spring
09 Allen Screw
10 Plastic Ring
11 Stainless Steel Arm
12 O Ring
13 O Ring
14 Faucet Body
15 Cartridge
16 Cartridge Nut
17 Decorative Collar
18 Allen Screw
19 Handle
20 Black Rubber Gasket
21 Black Rubber Gasket
22 Plastic Mounting Bracket
23 Stainless Steel Washer
24 Stainless Hex Nut
25 Machine Screw
26 Braided Supply Hose (hot)
27 Braided Supply Hose (cold)
KF10B Faucet Parts
