20
5. Quick system setup
A quick setup of a Quickselect chain is done in 3 easy steps:
1. Wiring devices
2. Device address awarding (manual or automatic)
3. Reading and saving EDID information of playback devices
Standard settings can be configured quick and easy using the following setup assistant procedures.
Specific individual settings can be made with a laptop using the free configuration software via the
RS232 connection.
5.1 Wiring devices
Connect all mains units to the devices, only tightening the cap nut manually. Do not connect the mains
units to the mains outlet.
Connect deactivated
QuickSelects
with a cat-6 cable (AWG 23), connect link output of the first device to
the link input of the next QuickSelect 3.0, proceed accordingly until all devices are connected in series.
Connect playback device to the HDMI output or to the HDBaseT Link-out of the last
QuickSelects
in the
series. (Input signals
downstream
of a playback device in the chain cannot be played back by it.)
5.2 Manual device address awarding
Using a flat-head small screwdriver set both BCD switches on the backside of the QuickSelect units to
individual addresses between 01…98. (Addresses 0 and 99 are reserved for special functions).
Media
control
RS232
HDMI VGA AUDIO
HDMI VGA AUDIO
HDMI VGA AUDIO
HDMI VGA AUDIO
RS232
RS232
Audio
HDMI
HDMI
max. 10 m
Link Out
Link Out
Link Out
Link In
Link In
