Kindcomfort KEL123, Инструкция по эксплуатации

Страница: 21 / 28

5. Make sure the vehicle’s safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle’s
safety belt or prevent the installation of the seat in any way. To
release your child unbuckle the vehicle safety belt as described in
the instructions.
When the seat is being used for group 1, the belt should go under the
headrest and this should be in its lowest position.
4. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 2 Y 3.
Use Group 2 y 3 only from approx.
4 to 6 years of age (15-25 kg)
WARNING
1. According to the child’s height the headrest can be adjusted up or
down. Place your hand on the headrest and press the lever while
pulling the seat down with the other hand so it does not move.
Always check that the harness straps are suitable for the height
of your child. (4.1).
2. Place the child seat on the seat of the vehicle, ensuring it is pressed
firmly against the back of the vehicle seat (4.2).
3. Place the child in the child restraint seat with height adjuster K at
the child’s shoulders (4.3).
4. Fasten the belt, ensuring that the lap belt goes through the guide
under both armrests and that the diagonal shoulder belt passes
through guide over and guide under the armrest that is next to the
vehicle anchor point. You will hear a “ click ” when this is properly
fastened. Ensure that the belts are not twisted and tighten by
pulling the diagonal shoulder belt upwards (4.4).
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps. Subsequently, install the seat belt
height adjustment as shown below.
IMPORTANT
Ensure that the belt has no slack.
21 www.kindcomfort.com Group 1/2/3
EN