kincrome KP2301, Руководство пользователя

Страница: 10 / 14

SMD LED WORKLIGHTS
10
ASSEMBLY
Note: The below assembly instructions covers models KP2301, KP2302, KP2303, KP2304 & KP2305.
Assembly of Floor Worklights (KP2301 & KP2302)
1.
Place the H frame stand (4) on a stable work area with the rubber feet facing down (Fig 1).
2. While holding the LED worklight in one hand, lower and place the light support frame (3) onto the H frame stand (4)
ensuring that the centre hole is aligned with the fastening hole (Fig 2).
3. Insert the light lock knob (5) through the light support frame (3) hole and screw into the H frame stand (4) fastening hole
and tighten by rotating clockwise (Fig 3).
(Fig 1)
(Fig 2) (Fig 3)
Assembly of KP2303 - 2 in 1 Worklight
1.
Release the telescopic stand lock knob (6) by rotating anti-clockwise (Fig 4).
2. Lower the telescopic stand legs (7) (Fig 5) until the legs are fully spread apart as shown in Fig 6 and re-tighten telescopic
stand lock knob (6) by rotating clockwise (Fig 6).
3. Release the quick release clamp (8) by lifting the lever upwards and fold the wire holders away from the
quick release lever (Fig7).
4. Place the assembled LED worklight onto the telescopic quick release clamp (8), fold the 2 small wire clips over the
H frame stand (4) (Fig 8), then locate the large wire clip over the top of the 2 small wire clips (Fig 8) and push down on the
quick release lever to secure the worklight onto the telescopic stand (5) (Fig 8).
(Fig 4)
(Fig 7)
(Fig 5)
(Fig 6)
(Fig 8)