6
PRESSURE WASHER 1520PSI
PRESSURE WASHER 1520PSI
Turbo Nozzle (14):
This nozzle rotates a powerful zero degree spray pattern in a circular motion. The spinning water jet hits the
surface area from multiple angles, increasing the intesnsity of the Pressure Washers making it effortless to remove tough dirt and
grime! This nozzle is ideal for cleaning large surfaces, such as driveways, concreted/paved areas, deckings, cars, boats and much,
much more! (Fig 5).
Note:
Care must be taken when using this nozzle to clean painted surfaces such as cars & boats. Ensure you begin cleaning these
surfaces from an extended distance to avoid surface damage.
Detergent Dispenser (15):
This nozzle is used when applying cleaning detergents onto your surface. This nozzle expels the detergent
at a high pressure, making it ideal to clean deckings, walls, concreted areas, cars, boats and much much more! (Fig 6).
Assembly
Connecting the High Pressure Hose to the Pressure Washers Inlet
Note:
Always ensure the original O-Ring seals are located on the end all connections when assembling components (Fig 7).
Note:
Always ensure the O-Ring are well lubricated with the appropriate lubricant (eg. Moly Bond Grease) (Fig 7).
1.
Remove the cable ties off the high pressure hose (9).
2.
Remove the black/clear coloured transport cap from the high pressure output connector (5).
3.
On one end of the high pressure hose (9) is a female threaded connector. Locate the female threaded end and connect onto the
high pressure output connector (5), by rotating clockwise (Fig 8) until secure.
4.
Remove the black/clear transport cap from the water inlet connector (8), located on the rear of the unit, then screw on the hose
adaptor (16) by rotating clockwise (Fig 9) until secure.
Assembling the Quick Connect Gun, Lance(s) & Nozzle Pieces
1.
The lance and gun comes in 3 peices;
- 1 piece quick connect gun (10)
- 1 piece extension lance (11)
- 1 piece lance (12)
2.
Connect the extension lance (11) to the quick connect gun (10) by feeding the extension lance into the quick connect gun (Fig 10).
3.
Push in the extension lance (11) and turn clockwise, until locked into position (Fig 11).
4.
Locate the lance (12) and feed the male end into the female end of the lance previously installed, turn clockwise to lock into
positon (Fig 12).
5.
Finally select the nozzle you require for the job at hand; adjustable nozzle (13), turbo nozzle (14) or the
detergent dispenser (15).
6.
Once selected, push in the blue button located on the side of the nozzle, feed onto the end of the lance (12), and release the
button. Ensure the nozzle is on securely (Fig 13).
(Fig 6)
(Fig 4)
(Fig 5)
(Fig 10)
(Fig 11)
(Fig 12)
(Fig 13)
1
2
1
2
(Fig 8)
(Fig 9)
(Fig 7)
