Kimoto Kimosetter 340, Руководство пользователя, Страница: 81 / 107

82
Chapter 5 - Troubleshooting
Media is not feeding correctly or not ejecting correctly
from the sheet feeder
Are you using the supported type of media?
Using an unsupported type of media can cause a paper jam. Always use
the supported type of media.
Are you using media with folded or cut corners?
This causes problems since the media position sensor and media length
sensor do not work properly.
Is there a paper jam?
Remove the media. If the media is caught in the rollers, open the front
cover, push down on the release lever, and gently remove the media.
Is there too much media in the sheet feeder?
The sheet feeder can hold up to 20 sheets of Kimoplate e 2 .
Is the media feed switch positioned correctly for the media feed method?
To print on Kimoplate e
2
using automatic feed mode, set the media feed
switch to position "A".
Is there anything blocking the output slot (such as a large pile of printed
sheets)?
This can cause ejection or feed problems.
Is anything getting in the way on the sheet feeder?
Turn off the printer. Check the sheet feeder, and remove whatever is in the
way.
Caution
•
Make sure to turn off the printer.
Cleaning the Transport Rollers.
Read the section “Cleaning the Transport Rollers”, and cleaning the Transport
Rollers.
Is the feed guide too narrow for the media?
The feed guide should hold the media loosely enough that it can feed easily.
Did you fan the media before loading?
Unfanned media can stick to each other with static electricty, and thus cause
more than one sheet to be loaded at one time.