Kimo DBM610, Руководство пользователя

Страница: 14 / 24

5. Using DBM610 in micromanometer mode
5.1. Starting up
The device is disconnected from airflow meter base.
➢
Press On/Off .
The device directly displays data below (see photo):
•
Airflow
•
Air velocity
•
Pressure delta
•
Temperature compensation
•
Type of airflow sensor used and size of the surface
5.2. Set the micromanometer
➢
Press "Menu" .
➢
Press "Left arrow" or "Right arrow" until reach "Configuration" .
➢
Press "OK" button.
The sub-menu
"Configuration"
appears with following data:
•
Airflow sensor: allows to select the airflow sensor used for the measurement: Pitot tube L, S,
Debimo blade, Matrix grid or Coefficient
•
Surface: allows to define the of surface and its size
•
Units: allows to define unit for airflow, air velocity, pressure and temperature
•
Damping: allows to smooth the measurement and avoid unwanted variations
•
Solenoid valve: allows to activate or not the solenoid valve
•
Thermocouple: allows to set the thermocouple type: K, J, T or S
•
Temp Compen: allows to set the compensation temperature
•
Standard airflow:
allows to activate or not the standardized airflow as per DIN1343 standard
5.2.1. Select the airflow sensor
➢
Go to "Airflow sensor" line then press OK .
➢
Press OK on the "Element" line.
➢
Select the airflow sensor (Pitot tube L, Pitot tube S, Debimo blade, Matrix grid or Coefficient) with up arrow and
down arrow then press
OK
.
It is also possible to select the corresponding coefficient to the airflow sensor:
➢
Go to "Airflow sensor" line then press OK .
➢
Press OK on the "Coefficient" .
➢
Select the coefficient from 0 to 9 with up arrow and down arrow then press OK .
Screen displays the required coefficient. It is possible to modify it with arrow buttons.
➢
Press
OK
to back to
"Airflow sensor"
sub-menu .
➢
Press
Esc
to quit
"Airflow sensor"
sub-menu and back to
"Configuration"
menu.
5.2.2. Set the surface
Set length and width of the surface:
➢
Go to "Surface" and press OK .
➢
Go to "Type" line then press OK .
➢
Press OK on “Lxl” line.
➢
Select the required dimensions with up and down arrows then press OK .
➢
If necessary, modify the length then the width with arrows then press OK (if no modification, just press OK).
Set diameter of the surface:
➢
Go to "Surface" then press OK .
14
Using DBM610 in micromanometer mode