�
Assembly
/
3. Slide the PVC rods into the pockets. It is recommended to do this manipulation in pairs.
4. Unfold the canvas (pay attention to the correct surface) and start by attaching 2 hooks to
each corner of the frame. Stretch the canvas only on the 4 corners. Continue with the other
hooks (Image 10, 11 & 12). Note: Be sure to protect the frame with one hand when
tensioning the springs. Perform this manipulation in pairs. The canvas can give the
impression of being too tight. Just apply more tension to the springs, in cold weather it
might be a good idea to let the canvas get to room temperature.
(picture
11)
(
pictur
e 12)
S.
Measure the distance between the two attachment points. The two wall attachments
should ideally be fixed 50 years from the outer edge between two springs. Record the
dimensions on the wall (level) and drill holes for the wall ties. Secure the wall brackets with
the plugs and screws provided (For concrete and / or stone} and hang the frame on two of
the wall brackets (
picture
13 & 14).
(
Pictur
e 13)
To hang the frame on the wall, both
people must perform the operation at
the same time.
�
Projection screen
/
Only f
ront projection screens (Image 1)
is
available. Position the
frame accordingly.
�
�
•
�
(
pictur
e 1)
Frame
I
Horizontal
aluminum bar
(@)
Vertical
aluminum bar
Check the scope of delivery and all the necessary parts.
H
F = 65mm
(until 240cm) F=86 (260 and
over
)
Outer frame height (H) afraid of projection screens up to 240cm image width =
Projection area (h)
+
130mm
Outer frame height (H) for projection screens larger than 240cm image width =
Projection area (h) +17
2
mm
Outer frame width (L) fear of projection screens larger than 240cm image width =
Projection area (1) +130mm
Outer frame width (L) for projection screens larger than 240cm image width =
Projection area (W)
+
17
2
mm
