Kimble Custom Chassis C6000, Руководство по безопасности

Страница: 19 / 106

Section 2 - Pre-Operation and Inspection
2-1 990001-014
SECTION 2 - PRE-OPERATION AND INSPECTION
2.1 PRE-OPERATION CHECK AND INSPECTION
Note: Complete all required maintenance before operating vehicle.
The pre-operation check & inspection, performed at beginning of each work shift or
at each change of operator, should include the following:
1. Cleanliness - Check all surfaces for leakage (oil, fuel or battery fluid) or foreign
objects. Report any leakage to the proper maintenance personnel.
2. Structure - Inspect the vehicle structure for dents, damage, weld or parent
metal cracks or other discrepancies.
3. Operation and Safety Manual - Make sure operator has read and is familiar
with Operation & Safety Manual located in cab.
4. Walk-Around Inspection - See page 2-4 for details.
5. Fluid Levels - Check fluids, including fuel, engine oil and coolant. When adding
fluids, refer to Section 9 - Specifications to determine proper type and intervals.
Before removing filler caps or fill plugs, wipe all dirt and grease away from the
ports. If dirt enters these ports, it can severely reduce component life.
6. Operational Check - Once the walk-around inspection is complete, perform a
warm-up and operational check (see page 2-7) of all systems. See Section
4 - Controls & Indicators for more specific operating instructions.
7. Any discrepancies or problems identified during inspection should be resolved
before start-up.
WARNING
FALL HAZARD. Use extreme caution when checking items beyond your normal
reach. Use an approved ladder. Failure to comply could result in death or serious
injury.
OA01 5 0
PARENT METAL CRACK WELD CRACK