Kilews SKD-BN512L, Руководство по эксплуатации и обслуживанию

Страница: 7 / 11

6
Attaching / detaching bit and bit type
Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and detached (single
finger notion type) select such a bit whose shank is equal to the size shown below.

Insert the power plug into a receptacle and set
the changeover switch to “
F
”
position.

Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to start
the motor running.

When the screw is tighten and reach the torque that you had set, The tool will stopped automatically.

To reset the tool by releasing the lever to the original position or releasing the bit From the screw head.

To return the screw, set the chang
eover switch to “
R
” position.
Maintenance and Inspection:
1. The screw driver must be operated in top condition, one day working hour must be
not more than eight hours.
2.
Please note don’t let the motor get over heated, every minute use 10~15 screws to operate.
3. The frequency use of this electric screwdriver is over than eight hours a day, still it needs periodically testing and
treatment. Every 5-6 months.
4. Inspect tool cords periodically and if damaged, have them repaired by an authorized service facility. Inspect extension
cords periodically and replace if damaged.
5. Do not remove any labels. Replace any damaged label.
Description of Operation
Servicing