6
Manual / Function
1.
Full Auto Shut-Off Screwdriver
It stops automatically when the screw has been tightened up and reached the set-up torque level.
The device will not cause damage of task since no continue running after screws are tightened.
(1)
Trigger Switch
The LED lights are on when the trigger switch has been pressed about one-third down, and then
the screwdriver starts functioning when the switch trigger has been pressed half way down; on the
contrary, it stops when the screw has been tightened up or the trigger has been released.
(2)
Forward / Reverse Switch
2-1 When the switch turn to the right as arrow indicates, the screwdriver will be clock-wise screwing
to tighten things up; Vice versa, left switch means to release the screw. As the diagram showing,
always set the switch to neutral position when the screwdriver is not being used.
Forward (screw) Reverse (unscrew)
2-2 Hi/Lo:to change the speed of rechargeable screwdriver, push Forward/Reverse lever to the
middle position, release the switch for about 0.5 second and press trigger switch for 5 seconds,
then there will be a short beep sound to adjust the position.
1) It represents Hi position when the power/Hi&Lo indicating light is off.
2) It represents Lo position when the power/Hi&Lo blue indicating light is lit constantly.
2-3 Hi/Lo Switch:When the rotating speed needs to be changed, set up the switch to Hi for the fastest
rotation, and setup the switch to Lo for slowest rotation. It's possible that the uncompleted shut-off
occurs when the switch is setup to Lo and the presetting torque is more than 50% of torque range.
Please refer to the following table.
Lo Switch Shut-off
MYBT-AS0320
MYBT-AS0830
MYBT-AS1545
OK
1( N.m )↓
1.5( N.m )↓
2.25( N.m )↓
NG
1( N.m )↑
1.5( N.m )↑
2.25( N.m )↑
