12
To adjust the torque on these screwdrivers. Proceed as follows :
1.
Determine the torque output of the tool by checking a tightened Fastener
with a torque wrench.
2.
Increase or decrease the torque by rotating the Spring Adjusting Ring.
Rotating the Ring clockwise to a higher number on the torque Scale
increase torque output while rotating the Ring counterclockwise to a
lower number decreases the torque output.
3.
Check the adjustment with a torque wrench. A number of factors will
affect torque output from one job to another. Final torque adjustment
should be made at the job through a of series of gradual increase. Always
start below the desired torque and work upward.
4.
Adjust the bit torque by changing the driving in length of the adjust ring
at the end.
5.
The relationship between torque scale and bit torque is as shown Ring, in
the torque diagram. The figures of torque scale do not indicate bit torque
values. However, the clamping torque of screw itself is different form
type, size, material of the screw and the material of its mating part. Use it
as standard to obtain an appropriate clamping torque.
6.
The (Return torque method) in which once-clamped screw is returned
with torque wrench or the like is available as one of torque control
methods however, note that the measured values by the return torque
method generally appear in 10%~30% lower than the actually clamping
torque.
7.
The torque checker measures the torque of screwdriver. The clamping
torque of screw itself is different from the clamped conditions.
Understand the correlation between clamping torque values and the
torque checker values perform the torque control properly.
1.
Please read the operation caution carefully before using our screwdriver, and follow the safety information to use this power
supplier.
2.
This model screwdriver must work with 6PIN power cord assembly and SKP-40BHL-800N(BC6PIN) power controller.
3.
Turn off the screwdriver before adjusting its torque.
4.
If switch the Forward/Reverse switch when the motor is still running, the protection program will be started to stop the motor.
You can restart the screwdriver to use as usual.
5.
The torque scale on the screwdriver is for reference only, not the real toque from the screwdriver.
6.
The wastage of the screwdriver depends on the torque for using, the using time, and the using frequency by the user. The
attrition rate will be higher under the higher torque for using, the longer using time, and the higher using frequency; A new
screwdriver with the torque scale 4, after 1 month ( 8 hours per day, operate frequency 12PCS per minute ) will lose 3~5%
torque. (lose 5~7% torque with torque scale 8 ). According to the time of using, the wastage will get less and become stable.
User can regular uses the torque meter to measure the torque to adjust the proper torque.
7.
If turn to “LO”on the power supplier, the screwdriver can’t offer high watt output, the torque on the screwdriver should be
adjust under middle range to use.
8.
Please refer to Kilews website http://www.kilews.com for the detail component list.
Attention
Torque Adjustment Operation
Содержание RBK120 Series
Страница 2: ......
