Kikusui TOS5050A, Руководство по эксплуатации

Страница: 38 / 120

4-4 TOS5051A/5050A
[2] START switch
If you press the START switch when the tester is in the READY state (“READY” is
lit), the tester will execute the test with parameters shown on the display screen. If
the “REMOTE” message is shown, the START switch is disabled and the remote
start control signal applied through the REMOTE CONTROL connector or the SIG-
NAL I/O connector is enabled.
If the MOMENTARY switch of TEST MODE switch on the rear panel is set to ON,
the test will be executed only while you hold down the START switch. For details,
refer to section 6.5, “Settings for Special Test Modes” (Page 6-29).
• Do not remote-control the tester simultaneously from both the REMOTE CON-
TROL connector and the SIGNAL I/O connector. If you do, the “REMOTE” mes-
sage will go out and the START switch will be enabled. For details, refer to
section 6.3, “Remote Control” (Page 6-20).
[3] STOP switch
The STOP switch is used to stop the test and reset the tester. When you press this
switch, the tester will behave as follows:
1. Clear the TEST status (“TEST” is lit)
The tester will stop the test and behave as follows:
(a) Turns OFF the output with the highest priority.
(b) Enables the discharge function if the test is in DC mode.
(c) Turns OFF the DANGER lamp, provided that there is no residual test voltage in
the output circuit.
(d) Turns OFF the “TEST” message.
(e) Turns OFF the TEST signal and the HV ON signal fed through the SIGNAL I/O
connector.
2. Clear the PASS status (“PASS” is lit)
The tester will clear the PASS status and behave as follows:
(a) Turns OFF the “PASS” message.
(b) Turns OFF the PASS signal fed through the SIGNAL I/O connector.
3. Clear the FAIL status (“FAIL” is lit)
The tester will clear the FAIL status and behave as follows:
(a) Turns OFF the “UPPER FAIL” message.
(b) Turns OFF the “LOWER FAIL” message.
(c) Turns OFF the U FAIL (upper fail) signal fed through the SIGNAL I/O connector.
(d) Turns OFF the L FAIL (lower fail) signal fed through the SIGNAL I/O connector.
NOTE