Kikusui PLZ-4W Series, Руководство пользователя

Страница: 111 / 218

PLZ-4W Applied Operation 6-21
6.6.3 Sequence Example (Normal Sequence)
Programs are created using the PLZ-4W operation panel. This section describes the
procedure of entering the following example sequence from the operation panel.
• Flow of the example sequence
In this example, we will assume a sequence that executes 2 programs (program
numbers 1 and 2) to simulate the waveform of Fig. 6-15.
As shown in Fig. 6-15, program 1 can be divided into 3 steps. After the execution of
the third step of program 1, the sequence continues to program 2. Program 2 exe-
cutes the 3 steps of Fig. 6-15 and ends the
fi rst loop. Here, we will set program 2 to
be executed twice. When program 2 is executed 2 times, this sequence operation is
fi nished.
Fig. 6-15 Sequence execution example
Program 1 CC mode (executed once)
1) 7 A 200 s LOAD ON
2) 7 A 150 s LOAD ON
3) 0.5 A 80 s LOAD OFF
Program 2 CC mode (executed twice)
1) 10 A 200 s LOAD ON
2) 5 A 50 s LOAD ON
3) 8 A 150 s LOAD ON
TRIG
TRIG OFF TRIG OFF TRIG
ON TRIG OFF TRIG OFF TRIG
OFF TRIG OFF TRIG OFF TRIG
OFF
10A
7A
8A
5A
Executio (RUN)
7A
200 s
LOAD ON 7A
150 s
LOAD ON 0.5A
80 s
LOAD OFF 10A
200 s
LOAD ON 5A
50 s
LOAD ON 8A
150 s
LOAD ON 10A
200 s
LOAD ON 5A
50 s
LOAD ON 8A
150 s
LOAD ON
Step 1
Program 1 Program 2 Program 2
Step 1 Step 2 Step 2 Step 3 Step 3 Step 1 Step 2 Step 3
Input current
CC
Setting