Kikusui PFX2731S, Руководство по эксплуатации

Страница: 28 / 54

28
Operation Manual
PFX2731S
Preparation | Connecting the DUT
Connect the DUT using the output cable, the sensing cable, and the temperature measurement cable.
1
Connect the temperature measurement cable to the TEMPERATURE connector of
the channel you will use.
2
Make sure that the POWER switch is on (p.29) . (The system is ready for tests.)
You can connect or disconnect the DUT connector and the SENSING connector even when the
POWER switch is on. However, you can do so only when no charge/discharge test is in progress.
3
Connect the output cable to the DUT connector of the channel you will use.
The DUT terminals have polarities. Install the terminal pins correctly so that the polarities, positive
(+) and negative(-), agree.
4
Connect the sensing cable to the SENSING connector of the channel you will use.
Tighten the connector screws to securely connect the cable.
5
If you use multiple channels, repeat Step 2 through Step 5 .
6
With the cables, which you have connected in the above step, connect the DUT to
this product.
7
After completing the connection to the DUT, attach the cover to the rear panel.
Run the cable through the notches located at the bottom of the cover.
The screws for installing the cover are made of resin. Be careful not to tighten them excessively.
Spacers
Rear panel cover
Run the cables through the notches on the cover.
Resin screw (M3x8)