Kikusui PFX2532, Руководство по эксплуатации

Страница: 41 / 142

PFX2532
41
2
C
o
nnec
ting and C
o
nfiguring De
vic
e
s
Preparing to Connect the DUT (Battery)
The PFX2532 does not come with cables for connecting to the DUT (battery). Prepare the following
cables according to the DUT (battery).
p. 23 , p. 123
There is an optional TL10-PFX cable set that contains cables for connecting PFX2532 and the DUT
(battery).
■
Cables and tools that are necessary to make the connection
Constructing sensing cables
See
Wire
• DUT cable
(stranded wire)
Cable for running charge/discharge current between the PFX2532
and DUT (battery)
See Table “Nominal cross-sectional area of wires and allowable
currents (reference)” (
p. 28 )
• Voltage sensing cable
Cable for sensing the electrode voltage of the DUT (battery)
0.20 mm
2
(AWG24) to 0.52 mm
2
(AWG20), shielded cable
See “ Constructing sensing cables” ( p. 41 ).
• Temperature sensing cable
Cable for sensing the temperature of the DUT (battery)
0.20 mm
2
(AWG24) to 0.52 mm
2
(AWG20), shielded cable
See “ Constructing sensing cables” ( p. 41 ).
Flat-blade screwdriver Shaft diameter: Ø3, blade tip width: 2.6 mm
Wire stripper A wire stripper that matches the wires listed above
DUT cable
PFX2532
Example of connecting the PFX2532 to the DUT (Battery)
Voltage sensing cable
(shielded cables)
Temperature sensing cable (shielded cable)
DUT (battery)
Thermistor
+
+
S
+DUT
–
–DUT
–
S
+
T
–
T
Pin no. Symbol Description
1 +S Positive voltage terminal. Connect to the positive terminal of the DUT (battery).
2 –S Negative voltage terminal. Connect to the negative terminal of the DUT (battery).
3 +T Temperature measurement terminal. Connect the included thermistor.
4 –T Temperature measurement terminal. Connect the included thermistor.
5 FG
Shield grounding terminal. This is connected to the PFX2532 chassis. Do not
connect the shield electric potential anywhere on the DUT (battery).