Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 199 / 218

PAT-T 4kW
A-19
Appx
Setting changes (Sequence 1: TRANsient)
Using the TRIGger:SEQ u ence1 (or TRIGger:TRA N sient) s u bsystem allo w s the
VOLTage and CURRent settings to be synchronized u sing triggers. This is
convenient if yo u w ant to synchronize o u tp u t changes w ith the action of other
instr u ments s u ch as electronic loads. To reserve triggered settings, u se the
VOLTage:TRIGgered and FREQ u ency:TRIGgered commands.
:VOLTage 12.0 '
Set the voltage to 12.0 V
:CURRent 1.5 '
Set the c u rrent to 1.5 A
:VOLTage:TRIGgered 13.5
'
Set so that the voltage is13.5 V w hen triggered
:CURRent:TRIGgered 2.5
'
Set so that the c u rrent is 2.5 A w hen triggered
:TRIGger:SEQuence1:SOURce BUS
'
Set the trigger so u rce to BUS
:INITiate:SEQuence1
'
Initiate seq u ence 1
:TRIGger:SEQuence1
'
Apply a soft w are trigger to seq u ence 1
The TRIGger:SEQuence1:SOURce command sets the trigger source to BUS or
IMMediate. The INITiate command makes the trigger subsystem leave the IDLE
state and go the initiated state. When the Trigger Source is set to IMMediate, the
transient action is executed immediately causing the voltage and/or current to
change to a new setting. When the Trigger Source is set to BUS, the trigger
subsystem goes to the WTG (Waiting For Trigger) state.
If the trigger subsystem is in the WTG state and a software trigger is applied with
the TRIGger:SEQuence1 or *TRG common command, the transient action is
executed. When the operation is completed, the trigger subsystem returns to the
IDLE state again. When an ABORt or an equivalent command is sent without
executing the trigger, the transient action is cancelled, and then the trigger
subsystem returns to the IDLE state.
The TRIGger:SEQuence1 command applies a software trigger to the sequence 1
group. The *TRG command or the IEEE488.1 get (Group Execute Trigger)
command applies a software trigger to all sequence groups in which the trigger
function is initiated.