Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 117 / 218

PAT-T 4KW
7-11
7
Remot
e
Cont
ro
l
7.5.1 SCPI Command Syntax
Command syntax
This manual denotes SCPI commands using the following format.
(Example)
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]
{<current>|MINimum|MAXimum}
• There are two forms of SCPI commands, the long form in which the command is
written out in its entirety and the short form in which the letters written in
lowercase are omitted.
SCPI commands can be sent in the long form or short form.
• SCPI commands are not case sensitive. CURR, Curr, and curr are all accepted as
short forms of CURRent.
CURRENT, Current, current are all accepted as long forms.
• A space is required between the program header section and the parameter
section.
• Multiple parameters, when available, are concatenated using commas.
• Compound commands can be created by concatenating two commands with a
semicolon.
(Example)
SOURce:CURRent MINimum;VOLTage MINimum
This compound command is the same as entering the following two commands.
SOURce:CURRent MINimum
SOURce:VOLTage MINimum
The first command, SOURce:CURRent MINimum, sets the path to SOURce.
Therefore, the root node, SOURce, can be omitted in the second command.
An error occurs if a node that is not defined in the current path (except CURRent
and VOLTage) is designated.
• A colon is required between program headers.
• Commands of different subsystems can be concatenated using colons and
semicolons.
(Example)
SOURce:CURRent MINimum;:MEASure:CURRent?
This compound command contains two root nodes, SOURce and MEASure.
When the second or subsequent command starts with a colon, the path specified
by the previous command is cleared.
• The maximum number of characters that can be transmitted in a single line is
128.