Kikusui KDS6-0.2TR, Руководство по эксплуатации

Страница: 23 / 60

KDS6-0.2TR Basic Operations and Connections 19
Chapter 3 Basic Operations and Connections
This chapter explains the basic operations conducted from the panel face.
3.1 Initial Setting Values
When the KDS6-0.2TR is switched on, the setting values specified in Table 3-1
are displayed.
The KDS6-0.2TR is shipped from the factory with the setting values shown in Table
3-1. Setting values marked as “Enabled” under “Backup” in the table are saved in
the internal memory (powered by an internal battery). These settings are maintained
even if the power has been turned off.
To reset the KDS6-0.2TR settings to the factory values, press and hold the CH
SELECT key while turning the power on.
Table 3-1 Table of setting values
Backup Item Setting value (factory setting)
Not enabled RS-232C acknowledge message Returned (SILEnt off)
Service request enable register 0
OUTPUT Off
LOCAL/REMOTE LOCAL
OCP Clear
Switching panel indication with every voltage
setting or current read-out On (ACHSel 1)
Enabled Voltage setting (all channels) 0.0000 V
Channel selection Channel 1
Channel-1 current range 200 mA
Output ammeter sampling rate Normal mode
KEYLOCK Clear
GPIB address 1
RS-232C bit rate 19 200 bps