Kieback&Peter RBW322-FTL-902, Руководство по эксплуатации

Страница: 22 / 30

22 Decommissioning, Removal and Disposal
Issue 2015-01-09
10.2 Removal
10.2.1 Screw mounting
If you want to remove the room control module, proceed as follows:
► Insert the flat screwdriver into the notch between the room
control module and the holding plate on the right side.
► Use the flat screwdriver to press the holding bar and release the
connection.
► Slide the room control module upward.
► Separate the room control module from the holding plate.
► Remove the screws by turning the flat screwdriver in counter-
clockwise direction.
10.2.2 Adhesive mounting
If you want to remove the room control module, proceed as follows:
NOTICE
Damage to the mounting surface!
If an adhesive pad other than the one supplied is used, or the mounting surface is tex-
tured and does not offer sufficient load-bearing capacity, the mounting surface may
become damaged when the adhesive pad is removed.
► Only use the adhesive pad supplied when mounting the holding plate.
► Only adhere the device to smooth, resistant surfaces (e.g. tiles) and not on tex-
tured surfaces that can easily become damaged (e.g. textured plaster, woodchip
wallpaper).