5
2
3
3
.
Plug the charger connector into the
battery.
Use
ONLY
the 12-volt charger included
with the Fire Engine (Input: AC120V–,
0.5A, 60Hz Output: +15VDC, 1.5A).
NOTE:
No metal contact intended to be
in this area. Correct as shown.
2
.
Unplug the engine connector from the
battery.
Connect Charger to Battery
1
1
.
Use a flat head screwdriver to
unlock the two screws at the
center of the seat. Lift seat.
Lift battery cover.
ONLY AN ADULT CAN CHARGE AND RECHARGE THE BATTERY.
NOTE:
It is not necessary to remove the battery from the vehicle for charging.
However, if the adapter cord will not safely reach a 120-volt wall outlet, the battery
can be removed for charging (see pages 15 and 16).
Charge Battery Before Assembly
4
.
Plug the charger into a standard 120-
volt wall outlet. Light on charger will
glow RED.
The charger may feel warm during
charging. This is normal and not a
cause for concern.
Disconnect Charger from Battery
1
.
Unplug the charger from the wall outlet.
2
.
Unplug the charger connector from the battery.
3
.
Plug the the engine connector into the battery.
4
.
Position the cover over the battery.
5
.
Lower the seat over seat hooks (at back of seat).
Ensure seat belt is not caught. Lock two seat screws.
1a
4
2
3
-+
