Install the front axle:
put the flat iron suit on the bogie first,
distinguish the front and back of the steering shaft, do not reverse, insert it on
the bracket, and secure it with a pair of oft 8 gaskets and M8 nuts; [make sure
the steering rod is inserted in the swivel hole on the front shaft]
Install front wheel:
the center of the front wheel is aligned with the
front axle and can be pressed under a slight pressure. [the wheel is
mounted with one key]
[the same method for
installing the left and
right front wheels]
Install escape-pipe
＆
rear axle
＆
rear
wheel
6
Install
the
exhaust
pipe:
to distinguish the left and
right of the exhaust pipe, the card is
set on the vehicle body, and the one
side is fixed with
2pcs 4 X 12mm
black flat head screws.
Rear axle and rear wheel
installation:
as shown in the
figure, the rear axle base is fixed on
the vehicle body with 8pcs
Ø
4 X12
mm screws; then the drive motor is
installed, and the wheel is slightly
applied to the rear axle with a slight
force;
[The
wheel
is
one-key
installation][the right and left rear wheel installation method is the same]
