1 x
SW Top 1 x 4 x 26-7/8”
Step 4: Swing Side Assembly
Note: Pre-drill all holes using
a 1/8” drill bit before installing
the lag screws.
1759
1771
1748
1770
1757
H2
0369
2 x
Post 2 x 4 x 74”
1 x
SW Ground 1 x 5 x 60-1/4”
1 x
SW Floor 1 x 6 x 26-7/8”
1 x
Lower Diagonal 2 x 3 x 37”
1 x
Wall Mount 2 x 4 x 40-3/4”
1771
Hardware
Wood Parts
11 x
1/4 x 2” Hex Bolt
(1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
2 x
5/16 x 4” Hex Bolt
(5/16” lock washer, 5/16” flat washer, 5/16” t-nut)
1 x
1/4 x 3” Lag Screw (with 1/4” flat washer)
1770
1759
0369
1757
LS3
Hex Bolt Assembly
Lock
Washer
T- Nut
Flat
Washer
He x
Bolt
Predrill Pilot Holes for Lag Screw
Lag
Screw
Flat
Washer
Predrill 1/8”
pilot hole
Use factory drilled
hole as a guide
Fig. 4.1
Notice hole
location
H2
H2
LS3
H2
G4
H2
H2
1748
G4
Fig. 4.2
A:
To 2 (1771) Posts attach (1770) SW Ground and (1759) SW Floor using 4 (H2) 1/4 x 2” Hex Bolts (with lock
washer, flat washer and t-nut) in each board.
Be sure to keep bolts loose.
(fig. 4.1)
1759
1770
1771
G4
B:
Attach (1748) SW Top to each (1771) Post with 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, flat washer and
t-nut) Hex Bolts are to be installed from the back of the assembly.
Be sure to keep bolts loose.
(fig. 4.2)
C:
Make sure assembly is square and then fasten (0369) Lower Diagonal to (1770) SW Ground at an angle using
1 (H2) 1/4 x 2” Hex Bolt (with lock washer, flat washer and t-nut) and to (1771) Post using 1 (LS3) 1/4 x 3” Lag
Screw (with flat washer). (fig 4.2).
D:
Attach (1757) Wall Mount to (1759) SW Floor and (1748) SW Top with 2 (G4) 5/16 x 4” Hex Bolts (with lock
washer, flat washer and t-nut). (fig. 4.2)
E:
Tighten all bolts.
H2
17
Содержание F24145
Страница 40: ...NOTES 40...
