45
Warning!
To prevent tipping and avoid potential
injury, stakes must be driven 13” into ground. Digging or
driving stakes can be dangerous if you do not check first
for under-ground wiring, cables or gas lines.
A:
In the 3 places shown in fig. 12.1 drive the Rebar Ground Stakes 13” into the ground against (070) Front
Ground and both (111) Diagonals. Be careful not to hit the washer while hammering stakes into the ground as this
could cause the washer to break off.
B:
Attach ground stakes to (070) Front Ground and both (111) Diagonals using 1 (S7) #12 x 2” Pan Screw per
ground stake as shown in fig. 12.2 and 12.3.
C:
After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Step 12: Install Fort Ground Stakes
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Hardware
3 x
#12 x 2” Pan Screw
S7
3 x Rebar Ground Stake
Other Parts
Fig. 12.3
Fig. 12.1
F
ig. 12.2
SEE FRONT COVER FOR
SAFETY CLEARANCE
Front
S7
S7
070
111
Ground Stake
Ground Stake
13”
In Ground
110
111
111
Inside View
13”
In Ground
Содержание F23175
Страница 111: ...111 NOTES...
