Kidde P3010K-CO, Руководство пользователя

Страница: 13 / 22

7. NUISANCE ALARMS
This Smoke alarm is designed to minimize nuisance alarms. Cigarette smoke will
not normally cause the unit to alarm, unless the smoke is blown directly into the
alarm. Combustion particles from cooking may set off the alarm if it is located
too close to a cooking appliance. Large quantities of combustible particles are
generated from spills or when broiling. Using the fan on a range hood which
vents to the outside (non-recirculating type) will also help remove these combus-
tible products from the kitchen.
If the alarm does sound the smoke alarm pattern of 3 long beeps, check for fires
first. If a fire is discovered, get out and call the fire department. If no fire is
present, check to see if one of the reasons listed in “Locations to avoid” may
have caused the alarm.
SMART HUSH TM CONTROL: The SMART HUSH TM control that is extremely use-
ful in a kitchen area or other area prone to nuisance alarms. The SMART HUSH
TM
feature has the capability of temporarily desensitizing the alarm circuit for up to
10 minutes.
If you require further information please contact
Product Support at 1-800-880-6788 or write us at: Kidde, 1016 Corporate
Park Drive, Mebane, NC 27302. Our internet address is www.kidde.com.
* End of life hush feature. Silences end of life indication 3 days at a time for
a maximim of 30 days.
Operational
Mode
Visual
Indications
Audible
Indications Note:
Normal
Operation
Blink once every 60
seconds
None LED will flash every 60 seconds for
10 minutes following power on or
reset. After initial 10 minutes,
LED will flash once every
10 minutes
Test/Hush
Button Press
Blink with each alarm
pattern
Two sets of 3 long
beeps, pause, two
sets of 4 quick beeps.
Test/Hush button press will initiate
test sequence
Smoke Alarm
Hush
Blink once every 10
seconds
None (smoke alarm
silenced)
Alarm hush feature silences smoke
alarm for up to 10 minutes.
Low Battery Blink once every 30
seconds
Chirp every 60
seconds
Remove alarm, discharge, dispose of
unit, replace with new alarm.
Fault Mode
Fault code (2-12
flashes every 30
seconds)
Chirp every 30
seconds
Call Product Support. If fault
continues, remove alarm, discharge,
dispose of unit, replace with new
alarm.
End of Unit
Life*
2 blinks every 30
seconds
2 chirps every 30
seconds
Remove alarm, discharge, dispose of
unit, replace with new alarm.
End of Unit Life
Hush
None None (End of Life
chirps silenced)