34
Maintenance
To keep your smoke/CO alarm in good working order, please
follow these simple steps:
• Verify unit alarm, lights and battery operation by pushing the
test/reset button once a week.
• Remove the unit from attachment stud and vacuum the alarm
cover and vents with a soft brush attachment once a month to
remove dust and dirt.
REINSTALL IMMEDIATELY AFTER CLEANING AND THEN
TEST USING THE TEST/RESET BUTTON!
• Never use detergents or other solvents to clean the unit.
• Avoid spraying air freshener, hair spray or other aerosols near
the smoke/CO alarm.
Do not paint the unit. Paint will seal the vents and interfere with
the sensor’s ability to detect smoke and CO. Never attempt to
disassemble the unit or clean inside. This action will void your
warranty. Move the smoke/CO alarm and place in another
location prior to performing any of the following:
• Staining or stripping wood floors or furniture
• Painting
• Wall papering
• Using adhesives
Maintenance
• If 100ppm or more CO was detected (Peak Level Memory
triggered), with a previous CO alarm and a smoke alarm,
the green LED will flash every 16 seconds (alarm memory).
Pushing the test button will give the Smoke Alarm Memory
“Fire!” message, and will clear smoke alarm memory. Pushing
the test button a second time will give the Peak Level Memory
voice message and clear Peak Level Memory, but the green
LED will continue to flash, alerting you of the previous CO
alarm. Pushing the test button a third time will clear CO alarm
memory and initiate the test sequence.
2521-7203-00_V7b.indd 34
14-2-18 上午11:48