![background image](http://html1.mh-extra.com/html/kidde/kn-cob-bca/kn-cob-bca_user-manual_1965075008.webp)
F e a t u res and Operation of Digital Display and
Non-Digital Display Models
(continued)
Lights
Red Alarm Light
•
The red light flashing once every
30 seconds, accompanied by the
alarm “chirp”, indicates the
batteries need to be replaced, or
the unit has malfunctioned (see figure 8).
•
4 quick flashes with alarm – followed by 5 seconds off –
followed by 4 quick flashes with alarm (repeating pattern)
indicates the p resence of carbon monoxide. Refer to pages 18-
20 for instru c t i o n s on
What to do if the Alarm Sounds
.
Green Operate Light
The green light indicates the unit is
functioning properly (see figure 9).
The green light will flash every 30 sec-
onds indicating a CO reading is being
taken and when any button
is pressed.
Figure 8
Figure 9
F e a t u res and Operation of Digital Display
and Non-digital Display Models
(continued)
Test/Reset Button
The test/reset button is used to test the unit’s electronics and to
reset the unit during alarm.
Test the unit:
To test, press the test/reset button.
Test the unit weekly!
The unit will perform a self diagnostic test by cycling through the
alarm pattern.
Familiarize yourself and family members with the alarm pattern.
A CO alarm is 4 short beeps – followed by 5 seconds of silence –
followed by 4 short beeps. This cycle will repeat in the event of a
CO alarm. This cycle will continue for the first 4 minutes of a CO
alarm and then change to one cycle every one minute until the
device is reset or the CO is eliminated.
Note: For Digital Display Models
After the test/reset button is pressed, numbers appear on the
display. These are not CO readings and are part of the internal
testing process. Ignore these numbers !
D u e t o t h e l o u d n e s s o f t h e a l a rmw e s u g g e s t y o u p l a c e y o u r f i n g e r s
o v e r t h e s o u n d e r o p e n i n g w h e n t e s t i n g y o u r Kidde C O Alarm.
Reset
If the alarm is sounding, pressing the test/reset button will term i n a t e
the alarm. If the CO condition that caused the alert in the first
place continues, the alarm will reactivate. If the CO alarm sounds
again within six minutes, it is sensing high levels of CO which
can quickly become a dangerous situation.
If this happens follow
What To Do If The Alarm Sounds
on pages
18-20. Reactivation times depend on the amount of CO that caused
the CO alarm to initially alarm and the amount of CO present after
resetting the alarm.
14
15
810-2263_RevA_146_MAN_ENG 4/14/04 3:29 PM Page 14