Page 2 of 8
Fig. 3
Fig. 1
Fig. 4
Fig. 5
Amp Installation
1. Disconnect the negative battery cable.
2. Gently pull out on the panel just below the steering column, rotate down and remove. Fig. 1
3. Remove the two 7mm screws securing the plastic panel below the steering column indicated by the
arrow in Fig. 2, and the one 7mm screw near the kick panel. Also, remove the two 10mm bolts
securing the metal plate and remove plate.
4. Remove the dash end panel by prying loose with a panel removal tool. Fig. 3
5. Install the amp into position by lining up the holes in the amp bracket with the two holes for the bolts
that retained the metal plate. Fig. 4
6. Install the supplied 10mm bolt into the bottom hole and leave loose. Fig. 5
7. Reinstall the metal plate over the top of the amp bracket and replace the factory bolts and tighten.
8. Tighten the bottom bolt.
Fig. 2
